Crown CL4 Pdf User Manuals. View online or download Crown CL4 Brochure. We just took in a USED CROWN CL4!Features and Benefits: Low impedance compatibility for applications where high power, low impedance loads are the. DESCRIPTION. W @ 8 ohm stereo; Provides for both low impedance or high impedance outputs; 70 Hz high pass filter per channel; Shallow chassis.
|Published (Last):||26 September 2018|
|PDF File Size:||13.47 Mb|
|ePub File Size:||19.86 Mb|
|Price:||Free* [*Free Regsitration Required]|
Documents Flashcards Grammar checker. Low impedance compatibility for applications where high power, low impedance loads are the primary requirement.
The SST expansion system makes it easy to tailor your amplifier to a specific application or to add future technology as it develops.
Crown quality is available at the best dollar-per-watt ratio on the market. Also, visit the Crown Audio website at www. All measurements apply to amplifiers in stereo mode with 8-ohm loads and an input sensitivity of dB gain, 1-kHz at rated power unless other otherwise specified. Specifications for units supplied outside the U. See power charts below.
Safe with all types of loads.
Detachable 15A IEC connector with country-specific plug. Voltage Gain, 1 kHz, 1. North American units are 60 Hz only. A detented rotary level control for each channel located on the rear panel. Frequency Response, 20 Hz to 20 kHz at 1 watt: Signal to Noise Ratio, A-Weighted: Intermodulation Distortion 60 Hz and 7 kHz at 4: Damping Factor 8 ohm: Crosstalk, 20 Hz to 20 crownn Better than 50 dB below rated power.
Better than 40 dB from 20 Hz to 1 kHz.
Crown CL4 Manuals
DC Output Offset shorted input: May be used for troubleshooting cable runs. A red indicator for each channel which turns on when distortion becomes audible in the amplifier output. A red indicator for each channel which indicates amplifier has muted output.
Status may be monitored remotely by plugging into backpanel RJ11 Fault jack. A blue indicator that turns on when the amplifier has been turned on and has power. Contractor Series amplifiers are protected against shorted, open or mismatched loads; overloaded power supplies; excessive temperature, chain destruction phenomena, input overload damage and high-frequency blowups.
Four-terminal touch-proof barrier block.
Nominally 20 k ohms, balanced. Nominally 10 k ohms, unbalanced. Factory set at 1. Channel 1 controls are active; Channel 2 should be turned down. Rugged steel chassis is formed into a durable package, then finished with environmentally friendly powder coat for long life and ease of maintenance. With this unprecedented No-Fault protection, your new Crown amplifier is warranted to meet or exceed original specifications for the first three years of ownership.
Crown Audio CL4 User Manual | 1 page
During this time, if your amplifier fails, or does not perform to original specifications, it will be repaired or replaced at our expense. About the only things not covered by this warranty are those losses normally covered by insurance and those caused by intentional abuse. And the coverage is transferable, should you sell your amplifier. See your authorized Crown dealer for full warranty disclosure and details.
For customers outside of the USA, please contact your authorized Crown distributor for warranty information or call Crown International W, Mishawaka Rd.
Latest information available at www. Crown and Crown Audio are registered trademarks of Crown C4l. Other trademarks are the property of their respective owners.